§2024-10-16

• Take Off Mast 40:12

• The Must Bucket

• you could maneuver the motor with Mast down

• Take off the Shackle

• pull the sheet till the two shackle meet

• tidy up the sheet

• we will use the boom as a lifting arm,
  • so, tie up the reefing lines

in this video, the genoa is not taken off, but I think we should.

Genoa (sail) is a type of large jib or staysail that extends past the mast and so overlaps the main sail when viewed from the side.

• if Genoa is still on, please take the genoa sheets out.

• the Furler line

• Take the furler line out

• Make a stopper knot at the end of the Furler line

• pull it as shown below

§The block system to raise or lower the mast

• tie one end to here

• leave the other end like this

• take the other enf of the sheet all the way to the cabin top

§The Mast Base Pivert Futting

• take the pins out, and put it through the bottom of Mast like this

• put both pins back to secure it

• the other pin and secure it

§How to move th boom

• unscrew the bolt

• put the bolt away, and the boom is loose

• move the boo from stern to bow side

• Using the old bolt to fasten the book like this

• If the book is too high, lower it

• Fasten the block system the other end here

• Place the Spninaker hallyard right on the boom 48:00 ???

¶ The Mast supporting poles

• twist till firm inside this hole

• cling this long pole as

• and this one as

¶Tie the spninaker hallyard(is a line (or rope) ) to the reefing eye

• pull spninaker hallyard through this pole

• tie with two loops or three

¶The rigging linkfor new boat,

• only the port side???

¶How to take off the forestay

• pull down the blocking system line

• After you did the above procedure, the forestay should be loose

• take the pin off(never use the circular shape pin)

• now take out the pin and loosen the forestay

• put the forestay on the port side, if you have two people, let the other hold it